Product - LOSS IN WEIGH FEEDER
Loss in Weight feed systemis to accurately weigh and control the output of variable products either, continuously or as a batch.
The loss-in-weight system is normally supplied with a standard hi-tech metering screw feeder either single or twin screw from 15 mm to 250 mm diameter and output range from 1.0kg/hr to, in excess of 30,000 kg/hr.
The selection of the correct type of feeder from our extensive range is determined primarily by the type and specification of the material to be handled.
Optimum Loss In Weight measurement results are obtained where the product being handled has good linear volumetric feed:-from 0 to 100% of the required flow rate. In this situation, We expect ± 0.5% or better accuracy
Providing the controller can measure the change in weight,very low flow rates can beachieved. The limit on through put of a loss in weight system is the ability to refill the loss in weight hopper in the required time frame.
* Large hopper inlet eliminates material bridging.
* Suitable for use with very fine to coarse, or fibrous, particulate products.
* Easily removable front cover provides a safe and quick access for cleaning.
* Ideally suited to industries that require rapid clean down and product changes.
*Commonly utilized for Plastics, Bulk Foods, Recycling, Concrete, Cement, Aggregates, Grains, Fertilizers, & all dry powders, etc.